Trademark-tools SINGLE DRAWERWORKBENCH Manuel d'utilisateur

WORK TABLE & BACK BOARDASSEMBLY INSTRUCTIONS21 Staffern DriveConcord, ON L4K 2X2www.trademarktools.ca

WORK STATION ASSEMBLY (cont.)STEP 14Fix the reinforced metal plate (11) onto the back lower part of the assembled Table Top Board and secure tightly w

CONTENTS OF THE WORK TABLE & BACKBOARD CARTONABCDA. Bottom board (1198 x 598 x 6 mm)B. Table-top board (1198 x 598 x 15 mm)C. Holed back board (12

CONTENTS OF THE WORK TABLE & BACKBOARD CARTON (cont.)13. Top rail 1198 mm (2pcs)14A. Cross member 1186 mm (3pcs)14B. Cross member (with holes in c

TOOL BOARD ASSEMBLYSTEP 1Place the left holed back board support (15)and the right holed back board support (16)on a level surface.STEP 2Mount a cross

DRAWER ASSEMBLYSTEP 1Attach the drawer handles (10) to the drawer front panel (30) using the bolts, washers and nuts (type 7).STEP 2Assemble the drawe

WORK STATION ASSEMBLYSTEP 1Place left rear leg (20) and right rear leg (21)on a level surface.STEP 3Mount another cross member (14B)at the top of the

WORK STATION ASSEMBLY (cont.)STEP 4Place the four side rails (19) on the rear legs.STEP 6Place the left front leg (22) andthe right front leg (23) on

WORK STATION ASSEMBLY (cont.)STEP 9Place the work station in the upright position.STEP 7Mount a cross member (14A)between the front legs (on the upper

WORK STATION ASSEMBLY (cont.)STEP 12Place the table top board (B) on the topsection of the work station.STEP 10Slide the assembled drawer into placeal